I just made a PID controller in TIA portal to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here

I just made a PID controller in TIA portal to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here

I just made a PID controller in TIA portal to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here

I just made a PID controller in TIA portal to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here

I just made a PID controller in TIA portal to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here

I just made a PID controller in TIA portal to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here

I just made a PID controller to simulate a water tank in factory IO. When I open the PID Compact settings to tune the controller and press start I can change the setpoint value that shows below “Online status of controller” with a potentiometer in Factory IO, but the trendline on the graph shows 0.
enter image description here